Make your own free website on
Free Patterns Page

Tatted Wreath Pin

Materials List
2 tatting shuttles
Tatting thread of your choice
I used DMC Cebelia size 10 Thread color 699
pin back or small gold safety pin
6" - 7" of 1/4" red ribbon
white craft glue

starch for stiffening
glass seed beads to slip on the picots

page links Home Creative Stitchery Patterns Tatting Links How to Place an Order Buying Patterns Wholesale Free Patterns About Me & the Business

free tatted wreath pin pattern

Some hints to read before you start tatting.

  1. This wreath can be worn as a holiday pin or put on your tree for a miniature ornament. Because of the size of the thread it tats up very quickly and is a good size for wearing.
  2. If you want to add beads to the picots that join the rings but don't have a small crochet hook, here's how to attach the beads using a beading needle: Slip 1 bead on the threaded needle, put the needle through the picot, then up through the bead. Carefully slide the threaded needle out. Using a hook join the rings. The bead is not sewn on the picot, it is just slid on it.
  3. To make it easier to put a bead on the picot make the picots 1/4" long.
ch - chainp - picoths - half stitchds - double stitch
cl - closerw - reverse worksep - separate

Fill the shuttle but don't cut the ball thread.

1. first ring - 3 ds, p, 2 ds, p, 2 ds, p, 3 ds, cl. RW.

2. chain 3, p, 2 ds, p, 2 ds, p, 3 ds. RW.

3. second ring - 3 ds, join to last p of previous ring, 2 ds, p, 2 ds, p, 3 ds cl. RW.

4. repeat 2.chain

5. third, fourth, and fifth rings and chains- repeat 3.second ring and 2.chain

6. sixth ring - 3 ds, join to last p of previous ring, 2 ds, p, 2 ds, join to first p of first ring, 3 ds cl. RW.

7. repeat 2. chain.

Cut off the ball and shuttle threads leaving long enough tails to tie it to the bottom of the first ring.
Add a little glue to the knot. When it's dry cut off the ends.

Finishing the Pin
1. If you want to stiffen your tatting but don't have starch, mix 1 teaspoon of glue with 2 tablespoons of warm water. Stir until mixed very well. Dip your finished tatting into the glue mixture. Blot dry and lay flat to finish air drying.
2. Sew the pin to the back of the tatting using the same cebelia thread. Make a bow from the ribbon and glue or sew it to the front.

All done! I hope you'll enjoy making and wearing these pins. If you leave the pin back off them and add a string loop you'll have a Christmas tree ornament.
Tuck them in greeting cards. They do make great gifts!

This site was designed by B.J.Heisler.
© 2009 Heisler's Creative Stitchery
Last updated Oct. 2009

If you're in a hurry you can call me at
724-846-1621 from 1 PM to 4 PM eastern time.

If you need to write to me or send an order here is the address:
Heisler's Creative Stitchery
Billie Heisler
2703 Clayton Road
Beaver Falls, PA 15010

This site is best viewed with
Internet Explorer 6 and up
monitor set at 800 x 600 or wider
32 bit true color.